Daktronics S-100/S-200 - Manual (Page 17)

Mechanical Installation 2-2
2.3 Display Mounting
Reference Drawings:
Mtg. Detail; Top Hanging Mount, All Displays ............................................Drawing A-92315
Mtg. Detail; Rear Hanging Mount, 0.7” Displays ........................................Drawing A-92292
Mtg. Detail; Rear Hanging Mount, 1.2” and 2.1” Displays ..........................Drawing A-76158
It is the customer’s responsibility to ensure that the installation will meet local standards. The mounting
hardware must be capable of supporting all components to be mounted. Daktronics is not
responsible for the installations or the structural integrity of support structures done by others.
Daktronics recommends either a wall mount or a hanging mount method. A removable wall mounting
bracket and eyebolts for hanging are included with each display. Have all mounted displays inspected
by a qualified structural engineer.
Hanging Mount
The DataTrac has two pre-drilled holes in the top of the
display for use in the hanging mounting method. To
hang a displa y refer to Drawing A-92315 and the
following instructions:
1. Remove the two retaining screws from the top
of the display using a 5/32" Allen wrench (refer
to Figure 3).
2. Slide a washer over the threads of each eyebolt.
3. Insert the eyebolts into the pre-drilled holes on the display
(refer to Figure 4).
4. Hand-tighten the eyebolts.
Note: Hanging the display without using the supplied eyebolts
will negate the warranty. Attaching or hanging anything from the
display will render the warranty null and void.
Wall Mount
The DataTrac has eight (8) or twelve (12) holes on the back of the
display for the attachment of the wall mounting clips. Refer to
Drawing A-92292 or Drawing A-76158 and the following instructions:
1. Using the #8-32 screws or ¼-20 bolts provided with the display, attach the mounting clips
to the rear of the display as shown (refer to Figure 5 and Figure 6). Use all clips
Figure 3: Removing Retaining Screws
Figure 4: Eyebolt Insertion
Figure 5: Attaching the Wall Mounting Clip
Figure 6: Mounting Clip Placement; Rear View