Daktronics S-100/S-200 - Manual (Page 16)

Mechanical Installation
2-1
Section 2: Mechanical Installation
L
Note: Daktronics engineering staff must approve any changes made to the display. If any
modifications are made, detailed drawings of the changes must be submitted to Daktronics for
evaluation and approval, or the warranty may be void.
Refer to the appropriate shop drawing for your type of display during installation.
Reference Drawings:
Shop Drawing; S-***-4-24-0.7" ..................................................................Drawing A-89791
Shop Drawing; S-***-4-36-0.7" ..................................................................Drawing A-92153
Shop Drawing; S-***-4-48-0.7" ..................................................................Drawing A-92154
Shop Drawing; S-***-8-24-0.7" ..................................................................Drawing A-92155
Shop Drawing; S-***-8-36-0.7" ..................................................................Drawing A-92156
Shop Drawing; S-***-8-48-0.7" ..................................................................Drawing A-92157
Shop Drawing; S-***-12-24-0.7" ................................................................Drawing A-89360
Shop Drawing; S-***-12-36-0.7" ................................................................Drawing A-92158
Shop Drawing; S-***-12-48-0.7" ................................................................Drawing A-92159
Shop Drawing; S-***-4-*-1.2".....................................................................Drawing A-96635
Shop Drawing; S-***-8-*-1.2".....................................................................Drawing A-96637
Shop Drawing; S-***-12-*-1.2"...................................................................Drawing A-96639
Shop Drawing; S-***-4-*-2.1".....................................................................Drawing A-77323
Shop Drawing; S-***-8-*-2.1".....................................................................Drawing A-77321
Shop Drawing; S-***-12-*-2.1"...................................................................Drawing A-77322
2.1 Support Structure Design
Support structure design depends on mounting methods, display size and weight. The structure design is
critical and should be done only by a qualified individual. It is the customer’s responsibility to ensure
that the structure and connectors are adequate. Daktronics is not responsible for the installations
or the structural integrity of support structures done by others.
2.2 Display Ventilation Requirements
Fresh air inlets and exhaust vents should not be obstructed in any way. Using the Daktronics suggested
mounting methods will ensure proper ventilation. If you are using a different mounting method, consult
a Daktronics sales representative for clearance requirements regarding your particular display. If
ventilation requirements are not met, the display warranty will be void.