Daktronics S-100/S-200 - Manual (Page 18)

Mechanical Installation
2-3
supplied.
2. Mount the wall bracket or
brackets to the wall where the
display is to be located. Refer
to Drawing A-92292 or
Drawing A-76158 to
determine the location of the
bracket or brackets with
respect to the display. Be sure the bracket is mounted to sufficiently support the
weight of the display. Have all mountings inspected by a qualified structural engineer.
3. Set the display on the wall-mounted bracket. The
bracket fits onto the wall mounting clips as shown in
Figure 7. Open the display as described in Section
4.1. Using two (2) #8 screws, fasten the mounting
bracket to the rear of the display (refer to Figure 8).
The display should now be attached to the wall-
mounted bracket.
Note: Mounting the display to the wall without using the
supplied mounting clips and bracket will negate the display
warranty. Attaching or hanging anything from the display will
render the warranty null and void.
Figure 7: Mounting Bracket Placement; Rear View
Figure 8: Securing the
Mounting Bracket