Daktronics DF-12xx - Manual (Page 12)

1-2 Introduction
Figure 1 , below, illustrates the Daktronics drawing label. The drawing number is
located in the lower-right corner of each drawing. Listing the last set of digits and
the letter preceding them identifies drawings in the manual. In the example below,
the drawing would be referred to as Drawing A-181218. Reference drawings are
inserted in alphanumeric order in Appendix A.
All references to drawing numbers, appendices, figures, or other manuals are
presented in bold typeface, as shown below.
“Refer to Drawing A-181218 for the display dimensions.”
Additionally, drawings referenced within a particular section are listed at the
beginning of that section as shown in the following example:
Reference Drawing:
Mechanical
Specs, DF-1010-24, G3..................... Drawing A-181218
The model numbers of a Daktronics display can be found on the ID label on the
display. The label will be similar to the one shown in
Figure 2 . When calling
Daktronics Customer Service, please have this information available to ensure that
your request is serviced as quickly as possible.
Daktronics displays are built for long life and require little maintenance. However,
from time to time, certain display components may need replacing. The
Replacement Parts List in Section 4-11 provides the names and part numbers of
components that may require replacement during the life of the display. Most display
components have a white label that lists the part number. The component part
number is in the following format: 0P-____-____ (component) or 0A-____-____
(multi-component assembly).
Following the Replacement Parts List is an explanation of Daktronics Exchange
and Repair and Return Programs. Refer to these instructions if any display
component needs replacement or repair.
Figure 1: Daktronics Drawing Label
Figure 2: Display Identification Label