Daktronics Single-Section Outdoor LED Scoreboards - Manual (Page 17)

Scoreboard Troubleshooting 11
Setting the Driver Address
Since the same LED drivers can be used for many scoreboard models, each driver must be set
to receive the correct signal input, or address, for the model being used. Addresses are set
through the S1 dip switch on the driver (Figure 11) using a pen or small, pointed object.
Refer to the tables below to determine the correct address setting of the driver(s) in a
particular scoreboard model and see Drawing A-290261 in Appendix C for addressing
information of driver addresses 1 – 128.
Multiple Drivers
Scoreboards with multiple drivers operate using a master/slave driver configuration.
If it appears as though only a certain group of digits on the scoreboard is not functioning,
there may be a problem with the slave driver(s) or the power/signal connection from the
other driver(s).
Figure 11: Driver Address Dip Switch
Model
Driver #
& Address
BA-2003
FB-824
FB-2005
MS-918
MS-2002
MS-2003
MS-2006
MS-2011
SO-918
A1 11
MS-2004 MS-2012
A1 74
A2 75
SO-2008 A1 17
SO-2013
A1 13
A2 14
SO-2031
A1 17
A2 11
TI-215 TI-2024 A1 2
Model
Driver #
& Address
BA-515
BA-518
BA-618 BA-624
BA-2010
BA-2017
A1 61
BA-718 A1 62
BA-2004
BA-2005 BA-2014
BA-2019
A1 72
A2 70
A3 71
BA-2022
A1 64
A2 70
BA-1018 A1 12
CR-2003
A1 12
A2 13
BA-2011
A1 67
A2 68
A3 69
A4 1
BA-2016
A1 12
A2 11
CT-2001
FB-2410
TI-418 A1 1