Daktronics TN-2601 Outdoor LED Tennis Scoreboard - Manual (Page 13)

Mechanical Installation 7
Once the spring nuts are in place, refer to the appropriate section below for the type of
mounting hardware provided with the scoreboard.
I-Beam Clamps
This mounting method is used to mount a scoreboard to I-beams with a flange thickness of
1 /
4
" – 3 /
4
". If flange thickness is greater than 3 /
4
", longer bolts will be required at additional
expense.
Mounting hardware includes I-beam clamps,
1 /
2
-13 x 3" bolts, 1 /
2
" flat washers, and 1 /
2
" lock
washers. Refer to Figure 8 and Drawing A-1052565 in Appendix B.
1. Position the scoreboard at the front of the beams, and lift it to the desired height.
2. Slide a lock washer, flat washer, and I-beam clamp onto the bolt, and loosely screw
the bolt into the spring nut.
3. Position each I-beam clamp assembly as close to the I-beam flanges as possible.
4. Make final adjustments in the positioning of the scoreboard to ensure it is flush and
level, and firmly tighten all of the bolts.
Figure 8: I-beam Clamp Mounting Method, Rear Isometric View