beautypg.com

I-beam clamps – Daktronics TN-2601 Outdoor LED Tennis Scoreboard User Manual

Page 11

background image

Mechanical Installation

5

I-Beam Clamps

Mounting hardware includes C-channels; washer plates; I-beam clamps;

1

/

2

-13 x 3.5" bolts;

self-drilling screws; and

1

/

2

" square nuts, hex nuts, flat washers, and lock washers. Refer to

Figure 6 and Drawing B-1129110 in Appendix B.

Note: I-beams must have a flange thickness of

3

/

16

" –

3

/

4

". If flange thickness is greater

than

3

/

4

", longer bolts will be required at added expense.

1. Position the scoreboard at the front of the beams, and lift it to the desired height.
2.
Place a C-channel against the upper rear flange of the scoreboard next to each beam.
3.
With the C-channel as a template, use a

9

/

16

" bit to drill holes in the upper rear flange

of the scoreboard cabinet where the bolts will pass through. The bolts should be as
close to the beam as possible.

4. Slide a lock washer, flat washer, and I-beam clamp onto each bolt, then push the bolts

through the holes in the rear flange of the scoreboard cabinet and into the C-channel.

5. Place the 2 washer plates and

1

/

2

" square nuts inside the C-channel, and loosely

tighten the square nut onto the bolts.

6. Make final adjustments in the positioning of the scoreboard to ensure it is flush and

level, and then firmly tighten all of the bolts to 40 ft-lb torque.

7. Screw the self-drilling screws into the rear flange, snug up against the I-beam clamps.
8.
Repeat steps 2-7 for the lower rear flange of the scoreboard for every beam.

Figure 5: C-channel Mounting Method, Side View