Cybex 20040 Eagle NX Leg Press User Manual
Page 14
Cybex Owner’s Manual
14
6. Install compression spring and top guide rod cap onto guide rod. Slide spring loaded top
guide rod cap down guide rod until cap is clear of guide rod plate and install. Repeat for
opposite side.
1
5
3
4
2
Description
1 Top guide rod cap (2)
2 Guide rod (2)
3 Guide rod plate
4 Phillips head screw (4)
5 Plastic mount
7. Install four Phillips head screws securing plastic mount to guide rod plate.
Apply weight plate decal (if not already installed on weight plates)
1. Peel off half of backing from weight plate decals, making sure that the decals remain
attached to the front sheet.
Backing
Weight
decals
Front sheet
2. Place decals front sheet in the correct position on weight plates.
3. Insert a guide pin through each hole of the decals front sheet. (A guide pin can be anything
that fits through the weight stack hole, such as a weight stack selector pin.)
4. Align decals and rub them onto weight plates.
5. Remove front sheet, do not peel decals off of weight plates.
2
1
Description
1 Weight stack selector pin
2 Weight plate decal
6. Repeat above steps for other half of the weight plate decals.
- 20050 Eagle NX Leg Extension 20060 Eagle NX Seated Leg Curl 20120 Eagle NX Calf 20090 Eagle NX Abdominal 20070 Eagle NX Arm Curl 20030 Eagle NX Row 20130 Eagle NX Pulldown 20010 Eagle NX Overhead Press 20000 Eagle NX Chest Press 20080 Eagle NX Arm Extension 20190 Eagle NX Hip Torso 20100 Eagle NX Back Extension 20170 Eagle NX Glute 20180 Eagle NX Hip AB-AD