Cybex 770C Cycle Cybex GO - Manual (Page 27)

Cybex Owner’s Manual
27
Cybex GO Setup
Prerequisites:
• Coax cable with TV signal
• Netpulse Gateway installed and running, providing the connection via:
Wired (Ethernet) – Ethernet cable is connected to the Cybex equipment through a network switch
to the Gateway.
Wireless – Gateway has been installed in the facility using a unique wireless access point.
Cybex GO Monitor will not connect to any other routers in the area.
• Power to the Cybex Equipment.
1. Install coax cable to the coax cable in base of unit.
1
2
Item Description
1 14 Ethernet Cable
2 Coax Cable
2. For wired networks, Install ethernet cable with ethernet coupler in base of unit.
Use the following instructions to setup the unit.
1. Plug the power cord into a power outlet from a grounded circuit as described under Electrical
Requirements in this chapter.
2. The control panel will light up.
Cybex GO installer
The Cybex GO installer only occurs during the initial installation of the unit. Once complete, refer to
Initial setup.
1. Tap “NEXT” to begin configuration.
1
Description
1 NEXT