Cybex 770C Cycle Cybex GO - Manual (Page 17)

Cybex Owner’s Manual
17
6. Route cables through gray clip on controller.
2
7
3
6
5
1
4
Item Description
1 Display Cable
2 Display Cable Connector
3 11 Power Cord
4 Coax and Ethernet
Cables
5 Console Cable DIN
Connector
6 Power Supply Output
7 Gray Clip
7. Plug the display cable into the display cable connector on the lower control board. Ensure the
cable connector is securely fastened.
8. Connect the console cable’s DIN connector to the power supply output. Make sure the two
connectors snap firmly together and can not be pulled apart without pulling the sleeve back to
release it.
Install front covers.
1. Install front left cover with one screw using a Phillips screwdriver.
2
5
4
3
2
1
Item Description
1 Plastic Connectors
2 14 Screw
3 4 Front Left Cover
4 Coax and Ethernet
Cables
5 5 Front Right Cover
2. Route coax and ethernet cables through front covers to front of unit. Do not pinch or damage
the cables during assembly.