CREATOR Wireless IR Interpretation System - Manual (Page 3)

Important Precautions
Warning
To ensure the proper function of the
equipment and the safety of the user, please
following the under mentioned instructions during
installation, use and maintenance:
Installation Instructions
◆
Please do not use the equipment in the
following environment: shaking, dusty, oily,
smoky, conducting dusty, filled of corrosive gas
and flammable gas. Also, please don’t expose
the equipment to high temperature, condensing,
wind, rain. Electrical shocking, fire and wrong
operation can also damage the product.
◆ When screwing and cabling, please don’t drop
the sweepings and wire leads into the controller’s
vent hole, or, fire, malfunction and wrong
operation may be caused.
◆ After the installation, please be sure that the
vent hole is not been blocked, or, the heat will not
be yielded properly and fire, malfunction and
wrong operation may be caused.
◆ Please don’t wire or plug/unplug the cable
while it’s still live, or, electrical shock and circuit
damage may happen.
◆ The installation and wiring should be stable,
and the poor contact may cause wrong
operation.
◆ In the place where sever interference exists,
shielded cable should be used as the I/O cable
for the high frequency signal to improve the
transmitting quality.
Wiring Instruction
◆
Before the installation and wiring, please cut
all the power supply, or electrical shock or
damage to the equipment can be caused.
◆ This product should be well grounded before
using.
◆ After the installation and wiring, all the
sundries should be cleaned up, and the covers
and panels should be put back and fixed well in
order to avoid electrical shock.
Operation and maintenance instruction
◆
Please don’t touch the connectors when they
are electrified, or electrical shock or wrong
operation may happen.
◆ Please cut the power first before cleaning the
cleaning and winding up the connectors.
Operation when they are electrified can cause
electrical shock.
◆ Please cut the power first before wiring or
disconnecting the communication signal cable,
extension modules or control units, or damage
can be caused to the equipments.
◆ Please do not dismantle the equipment to
avoid damages to the internal components.
◆ Please read this manual carefully, and ensure
that all your operations are safe before changing
the program, debugging the program, turning on
the system and stopping the operation.
◆ The button cell can only be replaced when the
equipment is not electrified. If the replacement
has to be done with the electricity is on, it should
be operated by professional person with
insulating gloves on.
Product Disposal instruction
When disposing the product, please take the
following instructions: