Contemporary Control Systems BASrouter Application Guide - Manual (Page 19)

AG-BASRTB00-BD0 Page 19
Application Guide — BASrouters
C
ONTR LS O
®
CONTEMPORARY
Setup Tab Parameters
System Default Value Description
Device Description Blank Up to 80 characters chosen by the user.
Time Default Value Description
Set Date (YYYY, MM, DD) 1970,1,1 Wireshark captures especially use this value.
Set Time (hh, mm, ss) 0,0,0 Wireshark captures especially use this value.
Username/Password Default Value Description
Username admin Up to 80 characters chosen by the user.
Password admin Up to 80 characters chosen by the user.
Config Upload/Download Default Value Description
Select Configuration File ... Blank Browse... to a BASrouterLX configuration file, then click Upload.
Save Configuration File to PC n/a Click Save to save the current BASrouterLX configuration to a PC.
Firmware Upload Default Value Description
Select Firmware File ... Blank Browse... to a BASrouterLX firmware file, then click Upload.
Advanced Tab Parameters
BBMD Default Value Description
BBMD Enable Unchecked Check this if your BACnet communications will pass through multiple
subnets. Warning: If this is enabled when unneeded, the BASrouter will
search for nonexisting BBMDs — and so traffic efficiency will suffer.
BBMD UDP Port Primary Leave this unchanged, unless your BACnet communications involve two
BACnet/IP networks.
Accept FDR Unchecked Check this if the BAsrouterLX must communicate with BACnet devices
in other subnets where no BBMD is present — and if those devices are
capable of Foreign Device Registration.
NAT Default Value Description
Secondary BACnet/IP UDP Port 0000 If routing between two BACnet/IP networks, each network must use a
different UDP Port. Enter the remote port number here.
Secondary BACnet/IP Network 0 If the BASrouterLX routes between two BACnet/IP networks, each network
must use a different network number. Enter the remote network number here.
Public IP Address 0.0.0.0 If the BASrouterLX has a non-routable local IP address (e.g., 192.168.92.68)
and communicates with BACnet devices across a firewall, enter the public
IP address of the NAT router. This will be the IP address of the remote side
of the NAT router which must be configured so that remote traffic — specified
by the Secondary BACnet/IP Network setting — is port-forwarded to the
BASrouterLX. This value is used in the Forwarded-NPDU IP Address field.
Slave Proxy Default Value Description
Slave Proxy Enable Unchecked Check this to allow the BASrouterLX to proxy MS/TP slave devices.
Auto Proxy Enable Unchecked Check this to discover slaves automatically then click View Auto Slaves.
Manual Slave Proxy Entry Unchecked Click the Apply button to add your entry to the Slave Proxy Table.
Broadcast Distribution Table Default Value Description
BBMD IP Address Blank The IP Address of the BBMD that will communicate with the BASrouterLX.
Broadcast Distribution Mask 255.255.255.255 The BBMD subnet mask — at its default value except in the rare cases in
which the intervening IP router is able to forward broadcasts.
Delete Entry No: Blank To remove an entry from the table, enter its number then click this button.
Special Parameters for the BASrouterLX