Contemporary Control Systems AI-SRVR Servers to Ethernet User Manual - Manual (Page 8)

TD000200-0MC
8
A Telnet session requires a login procedure as displayed in Figure 2 . The default login
string is “root” and it is echoed on screen. The default Password string is “ccsi2431”,
but it is NOT echoed on screen. If the login is successful, a Linux bash prompt is
displayed. From the bash prompt, two commands enable the user to choose the
operational function. These commands are config-srvr and config-proxy.
Figure 2
— Telnet Login Screen
4.1.4.4 Initial Access by a Telnet Session
The hardware arrangement for the initial setting of the IP address via a Telnet session
appears in
Figure 3 . The PC should be temporarily disconnected from the Ethernet
LAN in case the AI-SRVR default address matches that of another device on the
existing LAN. If it is certain that no existing device on the LAN uses IP address
192.168.92.68, then the computer can remain in the LAN. Otherwise, the procedure for
changing the IP address employs the creation of a temporary LAN composed of nothing
but the AI-SRVR, the computer used to configure it and a CAT5 cable connecting the
computer to the Ethernet port of the AI-SRVR. Consequently, this computer will be
unavailable for normal network functions until this procedure is finished.
Figure 3
— Setup for Initial IP Address Configuration by Telnet