Contemporary Control Systems AI Active Hubs - Manual (Page 11)

TD675100-0M
J
7
2
Installation
2.1 Introduction
2.2 Electromagnetic Compliance
The AI series complies with Class A radiated and conducted
emissions as defined by C
FR 47, Part 15 and EN55022. This
equipment is intended for use in nonresidential areas. Refer to
the following notices in regard to the location of the installed
equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
the
rules of CFR 47, Part 15. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
Warning
This is a Class A product as defined in EN55022. In a
domestic environment this product may cause radio
interference in which case the user may be required to take
adequate measures.
The AI series is intended to be panel mounted into an industrial
enclosure or into a wiring closet.
This can be achieved with
either panel-mounting brackets or clipping onto DIN rail as
described in Section 2.3.