Comtech EF Data SkyWire Quick Start Procedure - Manual (Page 8)

AN213 - Rev. 1.3
Skywire Quick Start Guide
8
4.3 BUC and LNB Configuration
To setup the BUC and/or LNB, select the corresponding tab on the satellite link configuration
window. Enter the LO and LO Mix. Click on the Enable button to activate the DC Supply and
Frequency Reference to the BUC or LNB. They are individually controlled with Checked meaning
that they are enabled, unchecked meaning that they are disabled.
Once satisfied with the new settings, click on the Apply button to have them take effect.
Care must be taken to insure that the DC Supply Enable in Disabled when
connecting the SkyWire Gateway to external equipment that cannot
accept a DC voltage input, such as a Spectrum Analyzer. Failure to do so
may result in damage to the external equipment.
Figure 4-5 BUC Tab Edit Mode