Comtech EF Data DST - Manual (Page 50)

Digital Satellite Terminal System Revision 1
Low Noise Block Converter MN/DST.IOM
4–8
4.4.4 Mounting Kits
Table 4-5. Optional: C-Band Waveguide ASB Kit, KT/2721-1
QTY Part Number Description
10 03P1079 Bolt, Hex, 1/4-20X1, SS
1 32D1002 Gasket, Half, Waveguide CPR229
1 32P1040 Gasket, Full, Waveguide CPR229
20 HW/1/4-FLT Washer, Flat, 1/4
10 HW/1/4-SPLIT Washer, Split 1/4
10 HW/1/4HEXNUT Nut, Hex 1/4
Table 4-6. Optional: Ku-Band Mounting Kit, KT/8924-1
(LNB to OMT)
QTY Part Number Description
3 32P1037 O-Ring
3 32P1039 O-Ring
4 HW/6-32 HEXNUT #6 Nut
4 HW/6-32x7/8 SHCS #6 Socket screw
8 HW/6-FLT #6 Washer, Flat
4 HW/6-SPLIT #6 Washer, Split
8 HW/8-FLT #8 Washer, Flat
8 HW/8-SPLIT #8 Washer, Split
4 HW/M4x12SHCS M4 x 12 Socket Screw
4 HW/M4x25SHCS M4 x 25 Socket Screw
4.4.5 LNB Installation
To install a single LNB:
1. If installed: Remove the protective covers from the LNB and TRF.
CAUTION
After removing the protective covers, ensure that no foreign
material or moisture enters the antenna waveguide or TRF.
2. Install the appropriate o-ring on the LNB or TRF, as follows:
a. If only one of the mating flanges is grooved, the thin o-ring should be
installed.
b. If both of the mating flanges are grooved, the thick o-ring should be installed.
3. Position the LNB (with o-ring) in place on the antenna OMT and install with
provided M4x12 socket screws and No. 8 SAE washers (split and flat).