Comtech EF Data D&I - Manual (Page 22)

D&I Revision 0
Connectors ans Switches MN/D-I.IOM
2–10
2.11 Faults (J11)
The Faults connection is an 8-position terminal block located at the front of the breakout
panel.
Signal Function Name Pin #
Ground GND 1, 5
Primary Common
Primary Norm/Open
Primary Norm/Closed PRI–COM
PRI–NO
PRI–NC 2
3
4
Secondary Common
Secondary Normally Open
Secondary Normally Closed SEC–COM
SEC–NO
SEC–NC 6
7
8
2.12 Data Interface (J12)
The data interface connection is a 50-pin female D connector located at the rear of the
breakout panel. Screw locks are provided for mechanical security of the mating
connector.
Signal Function Name Pin #
Ground GND 1, 2
Drop Data Input DDI–A
DDI–B 34
18
External Clock EXC–A
EXC–B 35
19
Insert Data Output IDO–A
IDO–B 36
20
Drop Data Output DDO–A
DDO–B 37
38
Terrestrial Tx Data
Terrestrial Rx Data TER–TXDAT
TER–RXDAT 5
7
Insert Data Input IDI–A
IDI–B 39
40
Primary Common
Primary Normally Open
Primary Normally Closed PRI–COM
PRI–NO
PRI–NC 10
43
27
Secondary Common
Secondary Normally Open
Secondary Normally Closed SEC–COM
SEC–NO
SEC–NC 11
44
28
Data Set Ready DSR 48
Terrestrial ESC DSR TER–ESC–DSR 41