Comtech EF Data CRS-170 - Manual (Page 17)

CRS-170 1:1 Redundancy Switch Revision 1
Installation and Operations Manual MN/CRS170.IOM
19
Chapter 2. INSTALLATION
IMPORTANT
For correct operation of the CRS-170 with CDM-600L, the CDM-600L
modems must have installed:
Firmware Version 1.1.4 (or higher)
Hardware Revision 3 (or higher)
If the modems do not meet this requirement, contact the factory for further
instructions.
2.1 U
NPACKING
Inspect shipping containers for damage. If shipping containers are damaged, they
should be kept until the contents of the shipment have been carefully inspected
and checked for normal operation.
Remove the packing list from the outside of the shipping carton. Open the carton
and remove the contents, checking the contents against the packing list. Verify
completeness of the shipment and that the unit functions correctly. If damage is
evident, contact the carrier and Comtech EF Data immediately and submit a
damage report. Be sure to keep all shipping materials for the carrier's inspection.
If the unit needs to be returned to Comtech EF Data, use the original shipping
container.