Code CR3600 - Manual (Page 14)

D013597_02_CR3600_User_Manual
19.0 - Reading Ranges
CR3600 Performance
Test Barcode Min Inches (mm) Max Inches (mm)
3 mil Code 39 3.1” (80 mm) 4.0” (102 mm)
7.5 mil Code 39 1.3” (33 mm) 7.2” (182 mm)
10.5 mil GS1 DataBar 0.8” (20 mm) 8.7” (220 mm)
13 mil UPC 1.1” (28 mm) 11.0” (280 mm)
5 mil Data Matrix 1.7” (43 mm) 4.5” (115 mm)
6.3 mil Data Matrix 1.3” (33 mm) 5.9” (150 mm)
10 mil Data Matrix 0.8” (20 mm) 7.1” (180 mm)
20.8 mil Data Matrix 1.1” (28 mm) 13.5” (343 mm)
Note: working ranges are a combination of both the wide and high density fields. All samples were high quality barcodes
and were read along a physical center line at a 10° angle. Default AGC settings were used. Accuracy= +/- 10%.
10
Important Note If Using a non-Code Bluetooth Device:
To connect to a Bluetooth device not manufactured by Code, you will need the Bluetooth address (often referred to as the BD_ADDR)
of that device. The 12-character Bluetooth address can be found on the device near the serial number. Then visit Code’s website at:
http://www.codecorp.com/bdaddr.php and enter the 12-character address to create the QuickConnect Code.
You will need to locate the Communications (COM) Port assigned to the Bluetooth serial port protocol before installing the Bluetooth
Configuration Manager software that is included with your Bluetooth adapter (e.g., COM 10). This is the COM Port through which the
CR3600 will connect.
Blue LED
Figure 35 Figure 36
18.0 - Establishing a Bluetooth® Connection
1. If establishing a Bluetooth connection using the Charging Station with embedded CodeXML® Modem, slide the Communication
Mode Switch on the Charger/Modem Station (Figure 33), to Bluetooth mode (the direction of the arrow).
2. Scan the QuickConnect Code located on the front of the Charging Station with embedded CodeXML® modem or on the external
CodeXML® M3 Modem (Figures 34 and 35).
3. The wireless icon located at the top of the reader will flash as it attempts to make connection (Figure 36). The blue LED on the
charging station or CodeXML® M3 Modem (Figures 35 and 36) will also flash as it attempts to connect. The blue LED will turn
solid when connection is established, the CR3600 will beep once and the wireless icon will flash every 10 seconds.
For additional CodeXML® M3 Modem configuration information, please reference the CodeXML® M3 Modem QuickStart Guide.
Storage Icon
Connection Icon
QuickConnect Code
Blue LED Wireless Icon
Good Read
Indicator
Communication
Mode Switch
Figure 33 Figure 34
Battery Charge
Indicator