Directed Electronics 20.7 - Manual (Page 22)

22 © 2008 Directed Electronics. All rights reserved.
Additional remote start features
Manual transmission
If the vehicle has manual transmission the proper steps must be followed before
leaving the parked vehicle or the remote start feature is disabled.
Make sure the engine is running and the doors are closed. 1.
Put the transmission in neutral. 2.
Press on the vehicle’s foot brake. 3.
Apply the emergency brake. 4.
Release the vehicle’s foot brake. 5.
Note:
Pressing the brake again after this
step will disable the remote start feature.
Within 15 seconds activate the remote start from the remote. 6.
The parking lights will flash 5 times confirming that the remote start is ac- 7.
tive. If the parking lights don't flash, then repeat steps 1 - 6.
Turn off the ignition (the car should stay running when key is turned off). 8.
Exit the vehicle and close the door. 9.
Lock the doors with the remote. (the vehicle shuts off when locking the 10.
system).
You can now remote start the vehicle. If a door is opened before the next remote
start activation the system will not remote start.