DeWalt DeVILBISS - Manual (Page 17)

17- ENG D23766
How to Start:
1. Turn the On/Auto/Off lever to
"On/Auto" and allow tank
pressure to build. Motor will
stop when tank pressure reaches
"cut-out" pressure.
2. Pull the regulator knob out and
turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to lock in place. The compressor
is ready for use.
NOTE: Always operate the air
compressor in well-ventilated areas
free of gasoline or other combustible
vapors. If the compressor is being
used to operate a sprayer DO NOT
place near the spray area.
Before Each Start-Up:
1. Place On/Auto/Off lever to "Off".
2. Check oil level in pump. See
"Oil" paragraph in the
"Maintenance" section for
instructions.
3. Pull regulator knob out, turn
counter-clockwise until it stops.
Push knob in to lock in place.
4. Attach hose and accessories.
NOTE: The hose or accessory
will require a quick connect plug
if the air outlet is equipped with a
quick connect.
Too much air
pressure causes a
hazardous risk of bursting. Check
the manufacturer’s maximum
pressure rating for air tools and
accessories. The regulator outlet
pressure must never exceed the
maximum pressure rating.
minutes. Make sure the drain
valve is open and there is
minimal air pressure build-up in
tank.
7. After 20 minutes, close the drain
valve (clockwise). The air receiver
will fill to "cut-out" pressure and
the motor will stop.
The compressor is now ready for use.