DeWalt DeVILBISS User Manual

Page 11

11- ENG

D23766

NOTE: Do not allow oil to be lower
than 3/8" (6 threads) from the top at
any time. When filling the crankcase,
the oil flows very slowly into the
pump. If the oil is added too quickly,
it will overflow and appear to be full.
Slowly fill crankcase to the top of the
fill hole. NOTE: Crankcase oil
capacity is approximately 16 fluid
ounces (473.2 ml).
3.

Replace oil fill plug (A).

Multi-Viscosity
motor oils, like 10W

30, should not be used in an air
compressor. They leave carbon
deposits on critical components,
thus reducing performance and
compressor life. Use air
compressor oil only.
NOTE: Oil is included with some
units. If oil is not included, use an oil
specifically formulated for use in an
air compressor, such as Porter-Cable
PAS1 air compressor oil. Oil may be
found at the store where the air
compressor was purchased.
1.

Place unit on a level surface.

Drain tank to
release air

pressure before removing the oil fill
cap or oil drain plug.
2.

Remove oil fill plug (A) and slowly
add a compressor oil until it is
even with the top of the oil fill
hole.