Caple C993i - Manual (Page 7)

7
INSTALLATION
Initial Light Conditions
In order to prevent a incorrect operation of the
keyboard, when the hob is connected, if the direct
environmental lighting conditions are excessive
(i.e. halogen hood lights on), the user interface
operation is stopped until the correct light
conditions are recovered.
The displays of the User Interface heaters are
switched on and the control operation stopped
5 mm
50 min.
Min. 4
20-40
Max. 50
ATTENTION:
To guarantee a correct functioning of the appliance it is important to
provide the work surface, during the installation, of a 4mm space for
the length of the recess on the front side of the furniture.
This, because the electrical controls have a guard which, if the
electronic system exceeds a 85°C temperature, switches off
the hob until the temperature returns below this limit. So during
the functioning, to guarantee a rush of air which maintains the right
temperature, a fan starts up.
Provide the assembling with an underlying cover which ensures
the rush of air from the back of the furniture or, if the hob is
installed over an oven, a suitable insulation to guarantee that the
temperature does not exceed 85°C.
Please provide a protection below to ensure the correct air flow
from the back of the cabinet, or, if the hob is installed above
the oven, please ensure adequate insulation to be sure of not
exceeding temperature.
If this happens it can cause damages to the electronic system, for
which the manufacturer does not have responsibilities.
Air inlet
Air outlet
Electrical connection.
•The appliance must be installed by a qualified
technician, who knows security and installation
rules in force. In particular, local power institution
rules must be observed.
•Check that the voltage indicated on the appliance
indicator plate corresponds to the voltage used in
your house. The indicator plate is placed in the
back side of the hob.
•The grounding is compulsory according to the law.
All the electric wires and grounding conductors
should have appropriate dimensions.
•The manufacturer declines all responsibility
for damages on person or things caused by
the non-observance of rules written above.
•The electrical connection between the hob
and a possible built-in oven must be installed
separately, whether for electrical safety
reasons, or to simplify the extraction of the
appliances.
In the case of a direct connection to the net, it
is neccesary to interpose a mono-pole switch
between the appliance and the net , with a minimal
3mm opening between the contacts.
The installer is responsible for the correct
electrical connection and of the compliance of
the safety rules.
Before beginning the connection ,make sure that:
•the cable has the grounding and is make
according to law;
•the cable could bear the highest load of the
machine, shown in the indicator placed on the
appliance;
•the charging voltage is included in the
characteristics indicator;
•the cable is plug-compatible with the appliance.
On the contrary replace the cable; do not use
extansions or multiplexes;
•the grounding wire (yellow/green coloured)
is connected to the terminal board on the point
indicated with the respective sign, and is longer
than other conductor wires;
•the cable must not undergo foldings or
compressions;
•the cable must be periodically controlled and
changed only by authorised technicians.
•the manufacturer declines all responsabilities
if these rules are not respected.