BUG-O Systems BVW-1000 - Manual (Page 15)

14
4. Installation Introductions
4.1 Security Notices
The equipment installation is forbidden before reading through installation instructions in
this manual.
Warning
Beware of electric shock
● Persons who install the equipment should be professionally qualified.
● Before installation, the input power switch should be switched off.
● The work-piece to be welded should be grounded well.
4.2 On-site Installation
After the EGW-BUG vertical welding is delivered to the construction site, the installation
of the machine framework should be conducted according to the plate amplitude. The
assembly operation may be carried out according to the following steps:
● Installation of the Power Source Rack (Electric Power Distribution Cabinet)
The power source rack (electric power distribution cabinet) should be installed close
to the storage tank or vessel to be welded. Meanwhile, it should be considered that the
welding cable and the control cable do not cross the service road and the location of the
power source rack is near the power network as possible. Additionally, it must be
grounded well. When several welding machines are applied simultaneously, they can be
lay symmetrically according to the cable length and the tank size.
● Assembling of Parts Inside of the Machine Framework
Parts inside of the machine framework are composed of the lifting device, operation
platform, the guide, the lighting, smoke exhaustion, cables and the transverse walking.
The parts of the machine framework are assembled before leaving the factory and there
is nothing but height adjustments of the driving wheel on site according to the real plate
amplitude. The adaptation range of this EGW welding machine on the plate amplitude is
1500mm-3000mm.
● Installation of Parts Outside of the Machine Framework
In this part, installations of the cable bridge, the gas cylinder rack, the top platform
and guardrails are included.