BSS Audio FDS-388 OMNIDRIVE Owner's Manual - Manual (Page 13)

13
H Utility Key
The Utility Key takes the user in and out of each edit screen's utility area. The
led is lit when in a utility screen.
Refer to Section 4.0 Getting Around
J Left/Right/Split Keys
These keys control which channel or channels the user is adjusting and which
channel is viewed. The leds serve to indicate whether the left and right
channels are set with the same values.
Refer to Section 4.0 Getting Around
K Edit Key
This key determines which of the three editing screens the user is in. The three
screens are:
Delay For setting band delays, phase adjustments and polarities.
EQ For setting equalisation for each band
XOver For adjusting band crossover frequencies and slopes and for
setting band gains and limiter thresholds.
Each screen has an associated blue led which is on whilst the user is in the
screen or a related utility screen.
A fourth press of the Edit Key takes the user back to the Default screen.
NOTE Pressing and holding the Edit Key in any screen will take the user
straight back to the Default screen.
Refer to Section 4.0 Getting Around
L Encoder (Parameter Wheel)
Pushing the parameter wheel will step around the current type of variables
allowing the user to select one to adjust.
Pressing and then turning the parameter wheel while still pressed will move
the highlight backward and forward through the current type of variables.
Turning the parameter wheel will adjust the currently selected variable.
Controls