Bronkhorst PROFIBUS-DP slave interface - Manual (Page 6)

BRONKHORST ®
1.4 S
HORT FORM START
-
UP
All necessary settings for this module are already performed at Bronkhorst.
To follow next steps carefully is the quickest way to get this module operational in your own PROFIBUS
environment.
START
Master
present
Load GSD
Make sure your master has been installed to the PROFIBUS system
Load GSD-file into the configuration tool. (Software at PROFIBUS master)
Copy bitmaps
Bitmaps (with flow controllers) can be copied in the proper directory (mostly
automatic, sometimes by hand; depends on program)
Add slave to PROFIBUS
system
Select "Bronkhorst meter/controller" and add new instrument to the bus (with
configuration tool)
Set slave configuration
Set parameter data
These settings will be copied to the instrument only at start-up. Examples of
useful parameters are: Fluid number, control mode, setpoint, counter and
alarm settings. Setting parameter data is not necessary, but optional.
Set slave station address
Default instruments will be delivered to customers on address 126. This is the
agreed station address for PROFIBUS DP systems for installing new instruments
to a system. Several methods for setting the stations address can be found in this
manual.
Download configuration Download all configuration settings into your master
Test data exchange
Test data-exchange communication between your master and the
instrument(s)
Ready
Select wanted modules out of available list with modules. These modules are the
parameters for instruments which are available for cyclic reading/writing by a
PROFIBUS DP master. Minimum selection will be probably "measure, integer
(read)" and "setpoint, integer (write)". These parameters will be stacked into
your master I/O memory. Inputs and Outputs will be stacked separately in order
of appearance of inserting the modules.
E.g.: if you also want to read-back setpoint from PROFIBUS, also select: "setpoint,
integer (read)"
Page 6 PROFIBUS DP interface 9.17.025