Dynamic Distributors Switch Cubes - Manual (Page 4)

4
Installing switch cubes
The switch cubes are designed to fit a 1” handlebar, and connect to the
front brake switch, and clutch switch (optional). Installing the switch
cubes involves drilling a hole in the handlebar where the switch cube
will be located, and another where the wires will connect to the display
module. These wires come with the ends already crimped on, but they
can be cut off and easily re-crimped in the event you need to fish the
wire through a small hole (see crimping instructions). After the hole is
drilled and the wire fished through, simply plug the connector into the
switch, and connect the two wires on the right side to the brake switch,
and the two wires on the left side to the clutch (optional). It is
recommended that an electrical grease (not included) be used on the
connector and socket to help prevent corrosion from moisture. Last
insert the switch into the housing, and install the four screws through the
back side of the saddle clamp.
I n s t a l l a t i o n