Dynamic Distributors Switch Cubes - Manual (Page 12)

12
Initial LINX™ Power-UP & Starting
Key Switch Operation:
When the key switch is turned on, power is applied to the LINX™
system and a self-test will run. If any faults are noted, they will be
displayed on the LCD screen. After this, a Logo and VIN # (if
programmed) will be displayed for 3 seconds, and then the LINX™
system will enter the operational mode. The following items will be
displayed on the screen in the operational mode:
• Digital Speedometer
• Digital & Bar-graph Tachometer
• Digital Odometer
• Time
• Information Window
• Neutral (if transmission is in neutral)
Auto Battery Conservation:
To conserve battery energy, when the key if first turned on, the headlight
will automatically be selected to low beam. Additionally, the LINX™
system will turn the headlight off during starter engagement. Once the
start button is released, the headlight will turn back on.
System Auto Shut Down:
If the key is turned on for 10 minutes, and the engine is not started, the
LINX™ system to include the headlight will turn off to avoid battery
drain; however, the marker lights will remain lit if the bike is wired with
marker lights. To reinitialize the system and start the bike, the key will
have to be turned off, and then back on.
Starting:
To start the motor while stopped: the transmission must be in neutral
and the Run/Kill switch must be in the “Run” Mode If an “X” is
displayed in the information window the bike is in the kill mode, if
nothing is displayed it is in the run mode. To complete the start, press
O p e r a t i o n / F u n c t i o n