Dynamic Distributors Switch Cubes User Manual
Dynamic Distributors Computer Accessories
1
C o n t e n t s
Introduction
Page 2
Instrumentation
Page 7
Operation / Function
Page 9
Programming
Page 18
Appendix
Page 21
All Rights Reserved. Reproduction by any means, electronic or mechanical
including photocopying, recording or by any information storage and retrieval
system or translation in whole or in part is not permitted without written
authorization from Signal Dynamics Corporation.
Copyright © Signal Dynamics Corporation.
Installation
Page 3
Wire Diagram
Page 22
Warranty
Page 24
Table of contents
Document Outline
- Locating Front Module
- Installing switch cubes
- Installing the Display Module
- To Replace the Connector End on a Cable.
- Front (Tank) Module
- The following outputs and operations are controlled by the Front Module:
- Rear Module
- Left Handlebar Switch Module Functions
- Turn Signal Function:
- The turn signal selection buttons are located on the left and right handle bar switch cubes. The turn signals are activated by pressing the appropriate button. The turn signals will flash for 7 seconds then automatically cancel. The number of flashes or
- Additional Features:
- Turn Signal Count Down: With self-canceling turn signals, it is a definite advantage to be able to know when the self-canceling feature will stop flashing the turn signal. This feature shows you the remaining flashes on the LCD display screen. When the t
- Turn Signal Hold: If the brakes are applied after a turn signal has been selected, the flashers will continue to flash as long as the brakes are applied plus 10 seconds. This feature is beneficial when stopped at a signal light, it will keep the turn sig
- Hazard Flashers: When selected will flash until cancelled and a hazard icon will be shown on the LCD display screen. To engage, depress both the left and right turn signal buttons for 1 second. To cancel, depress both buttons again for one second.
- Brake Lights: When the brakes are applied and the motorcycle is stopped, the brakes remain on until the bike accelerates. This will also cause the turn signals to continue to flash 10 seconds after the bike accelerates.
- Measured Mile Mode:
- Memory:
- System Specification: