beautypg.com

Reparing, Nstallation – Dacor DHI361 User Manual

Page 7

background image

5

p

lanninG

the

l

ocation

Carefully check the location where the hood is to be

installed. The hood should be placed for convenient

access. Make certain that electrical power can be

provided in the selected location.
Install the range hood and cooking appliance(s) so that

they can be removed if service is required.
Plan the installation so that all minimum dimensions

are met or exceeded (see page 3). Dimensions shown

provide minimum clearances, unless otherwise noted.

Preparing the Mounting Bracket Location

The mounting bracket must be attached directly to the

studs in the ceiling, or to a reinforced mounting block

secured to the studs. See below for mounting bracket

hole dimensions.

Attach the mounting bracket directly above the center

of the cooktop.
Attach the mounting bracket to the mounting surfaces

with #12 screws (not supplied). The screws must be of

sufficient length to penetrate into the wood mounting

surfaces at least 1 1/2” (3.8 cm).
The mounting surface must be level.

Allow clearance in the center of the mounting bracket

for the exhaust duct to pass through the ceiling

(8-inches in diameter).

e

lectrical

p

ower

S

upply

Electrical Specifications

It is the owner’s responsibility to ensure that the electrical

connection of this appliance is performed by a qualified

electrician. The electrical installation, including minimum

supply wire size and grounding, must be in accordance with

the National Electric code ANSI/NFPA* (or latest revision)

and local codes and ordinances.
Connect the hood to a 120 Vac, 60 Hz dedicated,

grounded, circuit protected by a 15 Amp circuit breaker or

time delay fuse.
*A copy of this standard may be obtained from:
National Fire Protection Association

1 Batterymarch Park

Quincy, Massachusetts 02269-9101

WARNING

The electrical service to the range hood should be

installed only by a licensed electrician.
Observe all governing codes and ordinances during

planning and installation. Contact your local building

department for further information.
DO NOT

use the mounting anchors provided with the

unit. They are part of a standard mounting hardware

package provided with many Dacor hoods, but not

suitable for use with this model.
The range hood is heavy. To prevent personal injury

and property damage caused by the hood coming

loose from the ceiling, mount the hood mounting

bracket only as specified below.

p

reparing

for

i

nsTallaTion

12 9/16”

(31.9 cm)

6 1/8”

(15.6 cm)

11”

(27.9 cm)

This manual is related to the following products: