Beurer EM 30 - Manual (Page 11)

11
3. Description of Device
Part names
1. Operating unit
2. LCD display
3. Program and lock key
4. On / Off / Pause key
5. Selection key - Increase intensity
6. Selection key - Reduce intensity
7. Battery compartment lid
8. Holder
9. Surface electrodes
10. Covers for electrode connection
If the self-adhesive covers for electrode connection are missing or become detached, we strongly
advise you to stick on the enclosed electrode covers.
Never attach the belt with bare metal electrodes. Use of the belt without electrode covers can cause
injury.
Description of the display symbols
A Battery status display: flashes if the battery is flat
B Intensity: set intensity levels 0 - 40
C Pause symbol: flashes if pause is activated
D Timer: remaining time for the program started
E Key: key lock is activated
F Program: selected program with the number of training cycles already
completed
4. Operation
Inserting batteries
If the battery symbol in the display flashes, the batteries are flat and must be replaced. The opera-
ting unit must be removed from the holder on the belt to insert or replace batteries.
– Release the magnetic connector by pulling the device away from the belt.
The magnetic connector of the two contact buttons clicks out noticeably.
– Pull the device upwards out of the holder.
– Remove the battery compartment lid by pressing and sliding in the direction of the arrow.
– Insert the batteries observing the markings in the battery compartment. Ensure correct battery
polarity.
3 4
5
6
7
8
2
1
10
9
A B C D E F