Beisler 1710-5 - Manual (Page 35)

2-13
3.7.2 Settings for this machine
The inputs and outputs at this machine should be programmed as follows:
Inputs
Start button
M1
STA
RT
Photo cell knife on
M2 Fn
F3 ON
F4 OFF F / F
Photo cell stacker stamp down and stacker start
M3 Fn F5 ON
F6 ON
Stacker transport in rear position and slide table open
M5 Fn F7 ON
Ouputs
Sewing foot
F1
programmed on Setup page -03
Knife (push valve)
F3 0 400 M
Knife (push valve)
F4 9 0 M
Stacker stamp
F5 7 800
Stacker transport
F6 7 800
Slide table
F7 0 30 M
Transportation belt down
F8
STEP
0 10
3.8 Meanings of the used symbols
Step type symbols
Pause - passing of a time
if the time symbol is programmed in a step, the program
sequence will be continued after the programmed time has
passed; outputs can be enabled in this step.