Beisler 1710-5 - Manual (Page 30)

2-8
3. Continue turning the hand wheel, until the needle stands at the upper edge
of the stitch plate.
4. Press the Plus key to accept the value as zero position.
5. Press the Special key to leave the page or set the needle top and bottom
positions.
Set needle top and bottom positions
These positions are defined as a factory setting but it is possible to change
them:
1. Position the cursor on the label „II Pos.“.
2. Turn the hand wheel in turn direction, until the needle stands in the desired
top position.
3. Read the angle value below the icon of the turn direction (est. 280).
4. Press the Plus or Minus key to enter the displayed angle value into the box
beside the label „II Pos.“.
5. Position the cursor on the label „I Pos.“.
6. Press the Plus or Minus key to enter the angle value „80“ into the box
beside the label „I Pos.“.
7. Press the Special key to leave this page.
3.4.2 Sewing speed (min. and max.)
Pull: 75
5400
[ ]
MAX.: 4200
MIN.: 400
DEC.
80%
ACC.
100%
RESET
ON
SETUP-02
67
Position the cursor on the listed values and press the Plus/Minus key to set
them as follows:
MAX.: 4200
MIN.: 400
ACC. 100 %
DEC. 80 %
Pull: 75
Press the Special key to leave this page.
3.4.3 Foot pedal
Hint
The settings contained here are optimized as a factory setting and must not
be modified.