BECKHOFF KL2502 - Manual (Page 20)

Terminal configuration
18 KL2502, KL2512
Interbus Coupler BK4000
By default, the Interbus coupler BK4000 maps the KL2502 with 6 bytes of
input and 6 bytes of output data. Parameterization via the field bus is not
possible. The KS2000 software is needed for configuration if it is intended
to use the control / status byte.
Offset Terminal1 Channel1 = 0
Offset Terminal1 Channel2 = 3
Offset Terminal2 Channel1 = 6
KL 2502 Channel1
KL 2502 Channel 2
The control-/status byte
must be inserted for
parameterization (KS2000).
K-Bus
Interbus bus coupler
BK4000
To the bus terminal
Data H
Data H
Data L
D1 - 0
D0 - 0
D0 - 1
D1 - 1
C/S - 0
C/S - 1
0
The terminal is
mapped in the
bus coupler.
Other bus couplers and
further information You will find further information on the mapping configuration of bus
couplers in the the respective bus coupler manual under the heading of
"Configuration of Masters".
i
Note
The annex contains an overview of the possible mapping configurations
depending on the adjustable parameters.
Parameterization with
KS2000 Parameterization operations can be carried out independently of the field
bus system using the Beckhoff KS2000 configuration software via the
serial configuration interface in the bus coupler.