BECKHOFF C3620 - Manual (Page 11)

Product Description
Interfaces from C3620/ C3640-0050
ATX motherboard
interfaces
PS/2 connections
PS/2 The upper PS/2 connector (X104) allows a PS/2 mouse to be used, while a
PC keyboard can be connected to the lower PS/2 connector (X103).
Serial interfaces
RS 232
COM1 – COM2
The basic version of the Industrial PC has two serial interfaces,
COM1 (X105) and COM2, using the type RS 232, which are each
brought to a 9 pin SUB-D plug connector.
The interface COM2 is located in the upper part of the first slot
right beside the ATX-slot.
COM2
USB interfaces
USB1 – USB4 The four USB interfaces (X108 – X111) are used to connect peripheral
devices with USB 2.0 connections.
Network connection
LAN1 The RJ-45 connector (X112) allows the PC to be connected to a
10/100/1000BASE-T Local Area Network (LAN).
LAN2 The RJ-45 connector (X113) allows the PC to be connected to a
10/100/1000BASE-T Local Area Network (LAN).
Sound-On-Board
Sound The Industrial PC has a on-board-interface with the following connectors:
Line In (X116), Line Out (X115) and Microphone jack (X114).
DVI-I (Digital Visual Interface)
DVI-I out The DVI connection (X117) is used for transferring the video signal. DVI-I
standard is supported.
DVI-D (Digital Visual Interface)
DVI-D out The DVI connection (X118) is used for transferring the video signal. DVI-D
standard is supported.
DisplayPort
DisplayPort The DisplayPort (X119) is used for transferring the video signal.
X116
X105
X104
X117
X115
X112 X113
X103
X118 X109 X111 X114
X119
X108 X110
Additional plug-in cards (optional)
Type plate There is a type plate on the top of the Industrial PC which provides
information about the hardware configuration of the Industrial PC at the
time it was supplied.
C3620, C3640 9