BECKHOFF C3620 - Manual (Page 10)

Product Description
Interfaces up to C3620/ C3640-0040
ATX motherboard
interfaces
PS/2 connections
PS/2 The upper PS/2 connector (1) allows a PS/2 mouse to be used, while a PC
keyboard can be connected to the lower PS/2 connector (2).
Parallel interface
Printer
LPT1 The parallel interface (3) corresponds to the Centronics standard, and is
addressed by the software as LPT1.
Serial interfaces
RS 232
COM1 – COM2
The basic version of the Industrial PC has two serial interfaces,
COM1 (4) and COM2, using the type RS 232, which are each
brought to a 9 pin SUB-D plug connector.
The interface COM2 is located in the upper part of the first slot
right beside the ATX-slot.
COM2
VGA connection
VGA A 15-pin SUB-D socket connector (5) allows a VGA monitor to be
connected.
USB interfaces
USB1 – USB4 The four USB interfaces (6 - 9) are used to connect peripheral devices with
USB connections. USB2.0 standard is supported.
Network connection
Network The RJ-45 connector (10) allows the PC to be connected to a Local Area
Network (LAN).
Sound-On-Board
Sound The Industrial PC has a on-board-interface with the following connectors:
Line In jack (11), Line Out jack (12) and Microphone jack (13).
3
10 11
1
Additional plug-in cards (optional)
Type plate There is a type plate on the top of the Industrial PC which provides
information about the hardware configuration of the Industrial PC at the
time it was supplied.
2
4 5
6
7 9
13
8
12
8 C3620, C3640