Displaying position, Navigation mode – Becker MAP PILOT OPERATION GUIDE User Manual
Page 43

43
NAVIGATION MODE
>>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> RUS
> With the 3D display, by selecting
3D-
Objects
you can select whether you
would like to see 3D attractions (
) or
not (
). At the same time, the
building display is turned on/off.
> With the 2D display, by selecting
Heading up
you can select whether you
would like the map displayed facing the
trip direction (
) or facing North
(
).
> With
Autozoom
, you can turn the
autozoom on
or off
.
> During the 3D display, select
Map tilt
angle
to change the angle of the map.
> Select one of the following angles:
Higher
,
Normal
and
Lower
.
> Save and close your settings by pressing
the
L
button.
Displaying position
You can display your current position and
then store it. You can also display
information on the current GPS reception
status.
> In the map toolbox, select
Information
.
The current position is displayed. An
address is displayed whenever possible.
The geocoordinates are displayed if no
address is available for the current
location.
During active navigation, the destination
address and potential stopovers are
displayed.
You can switch back to the map by
selecting
Resume guidance
(when
destination navigation is active) or
Return
to map
.
To get more user options, push the turn &
press controller towards the right.
You can save the actual position of the last
targets by selecting
Save
.
By Selecting
Country-Info
the current
country details such as the maximum
speed permitted and other regulations are
displayed for this country.
After selecting the displayed country at
the top of the screen, you can select other
countries from a list and see the
corresponding details.