Becker MAP PILOT OPERATION GUIDE - Manual (Page 40)

40
>>> NAVIGATION MODE
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> RUS
Display route list
You can have the route displayed on a list.
> When the entire route is displayed,
select Route list .
The route list is displayed.
Set route options.
You can set the route options.
> When the entire route is displayed,
select Options .
> Select
Route options .
> Configure the route options as
described under “Route options” on
page 45.
After any modification, the route will be
recalculated.
Simulate route
You can start a simulation of the route.
> When the entire route is displayed,
select Options .
> Select Simulation .
The route is simulated at four times the
usual speed.
By pressing the
button you are
brought to the next action event.
By pressing the
L button, the
simulation is stopped.
Block a route section
You can block a section of the route
ahead. You thereby set specific sections
that should not be driven. From Becker®
MAP PILOT, a detour calculation will be
attempted.
> In the route menu, select
Block ahead .
C
Note:
• Destination navigation is stopped
during section selection.
• The maximum length of a section is 31
mi. (50 km)
• During the section selection, you can
go back to the current point by
pressing the
L button.