BDI 1441 ERAS - Manual (Page 3)

ERAS
1441 1446
ASSEMBLY INSTRUCTIONS
3
BDIUSA.COM [email protected]
Step 3
Attach Base to Table Bottom
Place assembled base onto table bottom.
Insert Screws (E) into Base Rails (I and J)
and tighten using 4mm Hex Driver (A).
After all screws are tightened, turn table
over right side up.
Recommended
2-person Step
Eras 1446 End Table Only
Step 4
Attach Handle
Attach Handle (G) to Drawer using Screws (F)
and tighten with Phillips Screwdriver (A2).
To turn Table over
A2
G
F
F
A
E