BDI 9324 Cielo - Manual (Page 2)

Step 3
Install back panel.
Back panel is to be installed with the
elongated slots on the bottom and small
holes and label facing backward, do not
tighten screws and supports until all screws
have been started. Once all screws are
started, tighten ALL securely.
BDI label should be in one of the lower
corners.
Legs x 2
www.bdiusa.com
[email protected]
Shelf Frame/
Shelf Glass
Side Panels
x 2
G
x 4
x 7
Wire management
straps.
Velcro straps are supplied
to control cables. They
can be screwed into the
small holes on the back
panel.
J
K
A x 16
I
back panel
lower steel frame assembly
B x 8
leave loose until all are started
I
larger holes face
inward, smaller holes
face outward
Step 2
Build basic structure.
Note the orientation of upper/ lower
steel frames; the holes for back panel
supports must align.
Do not fully tighten back panel supports
until back panel is installed (Step 3). Then
tighten ALL fasteners securely.
C x 4
H
Step 1
Build lower frame.
Attach legs to front and rear
steel rails.
NOTE: The rear rail has holes
for attaching back panel
supports. Larger holes MUST
face inward for proper
alignment in Step 2.
lower steel front rail
x 1
lower steel rear rail x
1
back panel supports x 4
install but do not tighten
side panels x
2
upper steel frame
I
E x 4
legs x 2