BDI 2823 Casata - Manual (Page 3)

3
assembly instructions
bdiusa . com customerservice @ bdiusa . com
INCORRECT! Door
is out of alignment.
CORRECT! Door is
sitting squarely and
is evenly spaced at
top and sides.
Fine-tuning your Casata Home Theater Cabinet
Due to jostling in freight or perhaps an uneven floor, the doors and drawer (if equipped) on your Casata stand may not
appear to be in perfect alignment when first set up. Making a few minor adjustments can rectify this situation. Be aware
that depending on your situation, patience and a bit of trial and error may be required. The high-quality European hinges
are highly adjustable, and changing one element can cause the need for further adjustments. Through a few simple
adjustments, you can modify the orientation of the cabinet doors to ensure that they are hanging evenly.
STEP 1 - Level your cabinet (if needed)
After unpacking and assembling your Casata cabinet, inspect it visually to ensure that it is resting level on the floor, that
all doors appear level and open/close freely without rubbing or binding. Proper adjustment of the cabinet’s levelers quickly
corrects most leveling/alignment issues.
Models 8627 & 8629-2 only: There are five (5) adjustable levelers on the bottom of these cabinets; each may be
individually adjusted depending on your leveling scenario. Turning the leveler clockwise will extend the leveler; turning
it counter-clockwise will retract it. Four (4) of the levelers are accessible near the bottom of the side panels and are
adjustable using the provided Flat Wrench (B). One (1) leveler is accessible from inside the cabinet---in the center of the
bottom panel (Model 8627), or at the rear of the bottom panel (Model 8629-2)---and is adjustable using the provided
Allen Wrench (F).
Model 2823 only: There are six (6) adjustable levelers on the bottom of this cabinet; each may be individually adjusted
depending on your leveling scenario. Turning the leveler clockwise with the provided Flat Wrench (B) will extend the
leveler; turning it counter-clockwise will retract it. Four (4) of the levelers are accessible near the bottom of the side
panels, near front and back. An additional leveler is found on each center leg.
STEP 2 - Adjust Door Hinges (if needed)
The doors on your cabinet should be evenly spaced and should open and close freely without rubbing against the door
frame.
If the cabinet’s doors appear out of alignment, this condition can be
corrected with minor adjustments to the European hinges on each
door.
Because these hinges are infinitely adjustable, adjusting one
hinge element can sometimes cause the need for adjustments
to other elements. But with a few adjustments, you can modify
the orientation of the cabinet doors to make sure that they hang
perfectly within your cabinet.
Use Phillips Screwdriver (C) to adjust the door hinges:
By adjusting
•
Screw 1, the door will move LEFT or RIGHT
within the frame. Make minor adjustments at both top and
bottom hinges for best results.
By adjusting
•
Screw(s) 2, the door will move UP or DOWN
within the frame (the top and bottom hinges must be adjusted
the same degree).
By adjusting
•
Screw 3 the entire door will move IN or OUT,
opening or closing the gap between the door frame and cabinet
(This screw rarely needs adjustment).
1.
2.
3.
3.
1.
2.*
2.*