BDI 9760 Aspect - Manual (Page 4)

Step 5
Install UMB Bars. Find mounting screws that came with
your flat screen TV. If screws are not available, find the
short Phillips head mounting screws provided with Aspect
(provided in the second blister pack) that thread cleanly into
the mounting holes in the back of your TV. The following
thread sizes are included: M4, M5, M6, and M8. Attach
both UMB bars to TV as shown using washers and
Phillips screwdriver. Note: If back of TV has a curved
surface, or, if bars do not sit flat, use spacers and long
mounting screws provided. Make sure UMB bars are
centered left to right! Fully tighten bars to TV!
6. 7.
8. 9.
Install TV at desired height near by inserting the
threaded studs into key holes. Note* Nuts are pro-
vided in the second hardware blister pack and must be
threaded on the studs of the top UMB bar in order to
prevent any damage to the TV.
Once the threaded studs are positioned through the
key holes and slots, lower the TV into resting position.
Install the second set of nuts to the threaded studs
of the bottom UMB bar. Use Bubble Leveler
provided to ensure that TV is level. Once leveled, fully
tighten all of the nuts!
Install UMB cover plate by sliding it over the top of
the UMB face plate.