BDI 5156 EILEEN - Manual (Page 3)

3
assembly instructions
bdiusa . com customerservice @ bdiusa . com
Approx. 2”
Restraint Strap
Wall Screw
1/8”
Side Elevation
The rear edge of all shelves
(except bottom shelf) should be
approximately 1/8" from the wall.
Step 6
Once step 4 and 5 have been completed, lift assembled Eileen
against the wall.
Step 6 - Install Tipping Restraint Kit.
On the rear side of the top frame, there is a pre-drilled
hole for installing the HH510 Furniture Tipping Restraint Kit
(included).
This tip restraint must be attached to a wall stud using the
2" screw enclosed.
1. Attach a bracket to the back top rail or back top edge of
the shelf using the 5/8" screw provided, through the smaller
hole in the bracket.
2. Determine where the shelf is to be placed and mark
location on the wall over a wall stud for the wall bracket hole
approximately 2” below the mounting bracket secured to the
back of your shelf. Attach to the wall stud, using the 2" screw
provided, through the smaller hole.
3. Place the shelf into position so both mounting brackets are
vertically in line.
4. Lace the end of the restraint strap through the larger hole
in each bracket. Bring both ends together and slide the flat
end through the locking end and draw it through until all
slack is removed.
5. Confirm that strap is securely laced and locked.
Approx. 2"
To W
all
2" Wall Screw
5/8" Screw
To M
irror
Restraint Strap
*Note HH-510 Fur
nitur
e Tipping Restraint Kit
is supplied by W
alter of W
abash. For further
information, visit www
.walter
ofwabash.com