BDI 5130 PHASE - Manual (Page 4)

4
assembly instructions
bdiusa . com customerservice @ bdiusa . com
phase
5130
Correctly Aligned Incorrectly Aligned
Step 7
Align Wood Shelves with Metal
Make sure all Wood Shelves (C) are aligned and flush with the
Metal Supports (A1, A2, B1, B2). If anything is misaligned or
unevenly spaced, tap the Shelf (C) and Supports (A1, A2, B1, B2)
to its appropriate position. Once everything is flush and properly
spaced completely tighten the
Screws (F) with Hex Wrench (E).
Step 8
Retighten Wood Shelves
Retighten Screws (F) with Hex Wrench (E) on all Wood Shelves
(C) after a few weeks of use, as Wood Shelves (C) may contract
and fasteners may loosen due to varying humidity levels.
Step 9
Install Tipping Restraint Kit.
There is no pre-drilled hole on the rear side of the top shelf
for installing the HH510 Furniture Tipping Restraint Kit
(included).
This tip restraint must be attached to a wall stud using the
2" screw enclosed.
1. Determine where shelf is to be placed and mark the
location of a wall stud on the back edge of the top shelf. Drill
the provided 5/8” screw into the back edge of the top shelf at
the stud mark, attaching through the smaller hole in the
bracket.
2. Line the shelf back up to the determined wall stud and
mark the location on the wall for the wall bracket hole,
approximately 1” below the mounting bracket secured to the
back of the shelf. Attach to the wall stud, using 2” screw
provided, through the smaller hole of the bracket.
3. Place the shelf into position so both mounting brackets are
vertically in line.
4. Lace the end of the restraint strap through the larger
hole in each bracket. Bring both ends together and slide the
flat end through the locking end and draw it through until all
slack is removed.
5. Confirm the strap is securely laced and locked.
Approx. 2"
To W
all
2" Wall Screw
5/8" Screw
To M
irror
Restraint Strap
*Note HH-510 Fur
nitur
e Tipping Restraint Kit
is supplied by W
alter of W
abash. For further
information, visit www
.walter
ofwabash.com