BDI 9980 REVO - Manual (Page 2)

2
assembly instructions
bdiusa . com customerservice @ bdiusa . com
Step 5
Install Back Panel and Grommet
The back panel comes pre-installed. Follow illustrations below for
installation and removal. NOTE: Mouse hole is on bottom edge
of back panel.
It aligns with pre-installed Velcro strap for wire
management. Install Grommet (F).
F x 1
1
1
4 4 1 : Retention clip (C)
2 : Glass Shelf (A)
3 : Shelf Pin (B)
4 : Cabinet wall
Pin Assembly Diagram
Step 2 (continued)
Secure Glass Shelves
To secure the shelves on your Revo unit, it is necessary to use
the
Retention Clip (C), which is secured by the Shelf Pin (B).
Install
5.
Glass Shelves (A x 2)
Install 6. Retention Clips (C) as shown in “Pin Assembly
Diagram”
Secure by tightening the
7. Shelf Pin (B) with Phillips
Screwdriver (D).