Ignition system check – Baja Motorsports BR150-1 Operator's Manual User Manual
Page 44
41
IGNITION SYSTEM CHECK
1. Remove the spark plug and reattach it to the spark plug lead.
2. Turn ignition key to the “RUN” position. Slide the engine stop switch to the
“Run” position. Push the electric button “START “(grey button). Apply the rear
brake lever to make sure the rear wheels are locked. If the ignition system is
operating properly, a blue spark should jump across the spark plug gap. If there
is no spark, take your machine to your service center.
COMPLAINT: Engine stalls
1. Make sure there is enough fuel in the fuel tank.
2. Check to see that the spark plug is not fouled. Remove the spark plug and clean
it. Replace it, if necessary.
3. Make sure the fuel valve is not clogged, and the fuel tank is not clogged, either.
4. Check the idle speed. If necessary, adjust it using a tachometer. The correct idle
speed is 1400~1600 r/min.
Performing the spark test improperly could be hazardous.
You could get a high voltage electrical shock if you are not familiar with this procedure.
Do not perform this check if you are not familiar with the procedure. Do not point
the spark plug near the spark plug hole during this test. Do not do this test if you
have a heart condition or wear a pacemaker. Do not perform this test is any near
any open fuel containers for near fuel which has spilled on the ground, on the
engine, or any part of the Go-kart.
WARNING