Drive select lever – Baja Motorsports BR150-1 Operator's Manual User Manual
Page 24

21
DRIVE SELECT LEVER
Drive select lever adjustment
1. Press down the lever to the “D”
position so that the unit can move
forward.
2 Pull back the lever to “R” so that the
unit can move backward.
3. Adjusting Nut #1 at the end of the
cable can adjust the mesh status in
side the gear box; rotate the nut to
adjust the cable, and make sure that
the cable isn’t too tight or too loose.
4. Adjust Nut #2 accordingly.
Nut #1
Nut #2
The drive select lever shifts the Go-kart
in either forward or reverse
To shift Go-kart in either forward or reverse:
1. Release throttle
2. Apply brakes coming to a complete stop.
4. Shift lever down in the reverse position
5. Check for people or obstacles behind you.
6. Depress the throttle pedal gradually
continuing to watch to the rear while
backing.
Not looking behind vehicle before and while going in reverse could be
hazardous.
Failure to look behind while backing could cause the Go-kart to run into
an obstacle or person resulting in an injury.
Before going in reverse and while backing, look behind the vehicle for
any obstacles or people to avoid.
F R
WARNING