Operation, Resetting the temperature cutoff switch, Remote control – Dimplex DF3033ST User Manual

Page 11

not run on the remote operated

thermostat.

NOTE: When the manual

control switch is in the

Flame

Flame & Heat positions, the

fireplace unit will not operate

with the remote control.

C. Initialization Button
used to synchronize the remote

control with the fireplace.

Resetting the Temperature

Cutoff Switch

Should the heater overheat, an

automatic switch will turn the

heater off and it will not come

back on without being reset.

The temperature cutoff switch

can be reset by unplugging the

unit, waiting five (5) minutes and

plugging the unit back in.

CAUTION: If you need

to continuously reset the

heater, unplug the unit and

call Dimplex north america

Limited at 1-888-346-7539

for technical support. Please

have your model and serial

number ready when calling.

Operation

Remote Control

The remote control has a range

of approximately 50 feet (15.25

m), it does not have to be pointed

at the fireplace and can pass

through most obstacles (including

walls). It is supplied with 243

independent frequencies to

prevent interference with other

units.

Battery Installation

①

Depress tab on the battery

cover on the back of the remote

transmitter and remove battery

cover (Figure 5).

Figure 5

Batteries

Child Lock

②

Install two (2) aaa batteries

into the remote control (included).

③

Ensure child lock is in the

“unlocked” position (Figure 5).