Baby Lock Embellisher (EMB12-2) Manual - Manual (Page 7)

4
3. Remove and replace Finger Guard
Finger guard is a safety device to reduce
risk of injury.
If you would like to remove finger guard,
special care is required around the felting
needles.
To remove finger guard:
To replace finger guard:
a) Open the lamp cover.
b) Loosen the screw of finger guard by
turning it counterclockwise.
c) Remove finger guard.
d) Retighten the screw slightly by turning
it clockwise. This will prevent the
screw from vibrating out.
e) Close the lamp cover.
a) Open the lamp cover.
b) Loosen the screw for finger guard by
turning it counterclockwise.
c) Replace finger guard.
d) Tighten the screw by turning it clock-
wise.
e) Rotate handwheel several turns,
making sure needle clamp and needle
screws are not touching the finger
guard.
f) Close the lamp cover.