Baby Lock Embellisher (EMB12-2) Manual - Manual (Page 10)

7
5. Yarn Embellishing
Fig. 1 Fig. 2 Fig. 3
1. Rotate the yarn & ribbon guide toward the
back of the machine. Align the guide with
the top of the yarn stand pin.
2. Place yarn or thread on the yarn stand and
pull yarn end from center.
3. While sitting in front of the machine insert
yarn into the third hole of the yarn & ribbon
guide as shown in Fig. 1.
4. Wrap yarn to the underside of yarn & ribbon
guide and insert into the second hole as
shown in Fig. 2.
5. Once again, wrap yarn to the underside of
yarn & ribbon guide and insert into the first
hole as shown in Fig. 3.
NOTE: If the tension of yarn is too tight, use
only the third hole of yarn & ribbon guide. (Fig.
1)
If this does not help the tension check that the
yarn diameter is not too large. See page 8 for
additional information.